waveguide
blankbutton

TWS Calibration Kits

 

TWS calibration kits contain all the necessary components to fully calibrate your vector or scalar analyser for everyday waveguide measurements. We can customise these kits to your requirements

 

 
calibration kit 3

A typical kit contains:

 

  • waveguide to coax transition (N, SMA or K type
  • offsets
  • shorting plate
  • fixed load
  • any necessary screws and ancillaries
calibration kit 1

Specifying the kit...

Please contact us if you need assistance - typically this would include

  • connector type for the waveguide to coax transition
  • offset type (i.e. 1/8 and 3/8 wavelength or (0 and) 1/4 wavelength
  • any special requirements e.g. addition loads for isolation measurements etc

 
calibration kit 2
blankbutton020202

all rights reserved © 2010 The Waveguide Solution Limited www.waveguidesolution.co.uk T: +44 (0) 1626 835255
[Home] [data sheets] [Services] [about us] [U.K.] [Military] [Medical] [Aerospace] [Machining and fabrication] [Terrestrial communications] [Satellite communications] [Test and Measurement] [Waveguide hardware]